Custódio, D. A., & Ghisi, E. (2023). Impact of residential rainwater harvesting on stormwater runoff. Journal of Environmental Management, 326, 116814.
Abstract: Population increase, climate change and soil impermeability are factors causing floods in large urban centres. Such places also always have water shortage problems. This research aims to evaluate the influence of rainwater harvesting in residential buildings on stormwater in a basin located in southern Brazil (Rio Cachoeira Basin). Urbanised and non-urbanised areas, soil types, curve numbers and time of concentration of each sub-basin were taken into account. Through the HEC-HMS programme, it was possible to calculate hydrographs for the base scenario (when there is no rainwater harvesting). Then, rainwater tanks for the residential buildings were sized using the computer programme Netuno. In the second scenario, there is rainwater harvesting in all residential buildings. Thus, the hydrographs for the second scenario were also calculated. The peak flow reduction potentials for the sub-basins ranged from 2.7% to 14.3%. The highest percentage (14.3%) did not occur in the sub-basin with the most extensive roof area; such highest peak flow reduction occurred in Bom Retiro sub-basin. In Bom Retiro sub-basin, there are more houses than multi-storey residential buildings. Even when considering the full potential of rainwater harvesting for roof areas of all existing buildings in the Rio Cachoeira Basin, the average potential reduction in peak flow was 7.2%. The conclusion is that rainwater tanks in residential buildings have little influence on stormwater runoff, and the stormwater runoff will be less affected when the area of the hydrographic basin is larger. Thus, the reduction in peak flows is insignificant when considering the flooding in the region.
|
Mabrouk, M., Han, H., Fan, C., Abdrabo, K. I., Shen, G., Saber, M., et al. (2023). Assessing the effectiveness of nature-based solutions-strengthened urban planning mechanisms in forming flood-resilient cities. Journal of Environmental Management, 344, 118260.
Abstract: Cities have experienced rapid urbanization-induced harsh climatic events, especially flooding, inevitably resulting in negative and irreversible consequences for urban resilience and endangering residents’ lives. Numerous studies have analyzed the effects of anthropogenic practices (land use changes and urbanization) on flood forecasting. However, non-structural mitigation’s effectiveness, like Nature-Based Solutions (NBS), has yet to receive adequate attention, particularly in the Middle East and North Africa (MENA) region, which have become increasingly significant and indispensable for operationalizing cities efficiently. Therefore, our study investigated the predictive influence of incorporating one of the most common NBS strategies called low-impact development tools (LID) (such as rain gardens, bio-retention cells, green roofs, infiltration trenches, permeable pavement, and vegetative swale) during the urban planning of Alexandria, Egypt, which experiences the harshest rainfall annually and includes various urban patterns. City characteristics-dependent 14 LID scenarios were simulated with recurrence intervals ranging from 2 to 100 years using the LID Treatment Train Tool (LID TTT), depending on calibrated data from 2015 to 2020, by the Nash-Sutcliffe efficiency index and deterministic coefficient, and root-mean-square error with values of 0.97, 0.91, and 0.31, respectively. Our findings confirmed the significant effectiveness of combined LID tools on total flood runoff volume reduction by 73.7%, revealing that different urban patterns can be used in flood-prone cities, provided LID tools are considered in city planning besides grey infrastructure to achieve optimal mitigation. These results, which combined multiple disciplines and were not explicitly mentioned in similar studies in developing countries, may assist municipalities’ policymakers in planning flood-resistant, sustainable cities.
|
Baptista, V. S. G., Coelho, V. H. R., Bertrand, G. F., Silva, G. B. L. da, Caicedo, N. O. L., Montenegro, S. M. G. L., et al. (2023). Rooftop water harvesting for managed aquifer recharge and flood mitigation in tropical cities: Towards a strategy of co-benefit evaluations in João Pessoa, northeast Brazil. Journal of Environmental Management, 342, 118034.
Abstract: Intense urbanisation in many coastal areas has led to intensification of groundwater consumption, while reducing permeable areas and increasing the frequency and magnitude of flooding. Among the potential strategies to compensate for these adverse effects, which are expected to become worse as a result of climate change, rooftop rainwater harvesting (RWH) in combination with managed aquifer recharge (MAR), may be indicated. This work investigated the performance of different configurations of such a system, tested as a twofold sustainable stormwater and domestic water management tool in a tropical metropole (João Pessoa, Brazil). This area located over a sedimentary aquifer system illustrates the water security challenges of densely urbanised areas in southern cities. To that end, several configurations of rooftop catchments and storage volumes were evaluated, by simulating a MAR-RWH system connected to the regional unconfined aquifer (Barreiras Formation) through a 6″ diameter injection well. Rainfall-runoff-recharge processes and water balances were simulated using monitored high-temporal resolution rainfall data. The results showed that catchments ranging from 180 to 810 m2, connected to tanks from 0.5 to 30.0 m³, are the optimal solutions in terms of efficient rainwater retention and peak flow reduction. These solutions provided mean annual estimates of aquifer recharge between 57 and 255 m³/yr from 2004 to 2019. The results of this study highlight the opportunity for MAR schemes to reconcile stormwater management and water supply goals.
|
Milena-Pérez, A., Piñero-García, F., Benavente, J., Expósito-Suárez, V. M., Vacas-Arquero, P., & Ferro-García, M. A. (2021). Uranium content and uranium isotopic disequilibria as a tool to identify hydrogeochemical processes. Journal of Environmental Radioactivity, 227, 106503.
Abstract: This paper studies the uranium content and uranium isotopic disequilibria as a tool to identify hydrogeochemical processes from 52 groundwater samples in the province of Granada (Betic Cordillera, southeastern Spain). According to the geological complexity of the zone, three groups of samples have been considered. In Group 1 (thermal waters; longest residence time), the average uranium content was 2.63 ± 0.16 μg/L, and 234U/238U activity ratios (AR) were the highest of all samples, averaging 1.92 ± 0.30. In Group 2 (mainly springs from carbonate aquifers; intermediate residence time), dissolved uranium presented an average value of 1.34 ± 0.13 μg/L, while AR average value was 1.38 ± 0.25. Group 3 comes from pumping wells in a highly anthropized alluvial aquifer. In this group, where the residence time of the groundwater is the shortest of the three, average uranium content was 5.28 ± 0.26 μg/L, and average AR is the lowest (1.17 ± 0.12). In addition, the high dissolved uranium value and the low AR brought to light the contribution of fertilizers (Group 3). In the three groups, 235U/238U activity ratios were similar to the natural value of 0.046. Therefore, 235U detected in the samples comes from natural sources. This study is completed with the determination of major ions and physicochemical parameters in the groundwater samples and the statistical analysis of the data by using the Principal Component Analysis. This calculation indicates the correlation between uranium isotopes and bicarbonate and nitrate anions.
|
Dutova, E. M., Nikitenkov, A. N., Pokrovskiy, V. D., Banks, D., Frengstad, B. S., & Parnachev, V. P. (2017). Modelling of the dissolution and reprecipitation of uranium under oxidising conditions in the zone of shallow groundwater circulation. Journal of Environmental Radioactivity, 178-179, 63–76.
Abstract: Generic hydrochemical modelling of a grantoid-groundwater system, using the Russian software “HydroGeo”, has been carried out with an emphasis on simulating the accumulation of uranium in the aqueous phase. The baseline model run simulates shallow granitoid aquifers (U content 5 ppm) under conditions broadly representative of southern Norway and southwestern Siberia: i.e. temperature 10 °C, equilibrated with a soil gas partial CO2 pressure (PCO2, open system) of 10−2.5 atm. and a mildly oxidising redox environment (Eh = +50 mV). Modelling indicates that aqueous uranium accumulates in parallel with total dissolved solids (or groundwater mineralisation M – regarded as an indicator of degree of hydrochemical evolution), accumulating most rapidly when M = 550–1000 mg L−1. Accumulation slows at the onset of saturation and precipitation of secondary uranium minerals at M = c. 1000 mg L−1 (which, under baseline modelling conditions, also corresponds approximately to calcite saturation and transition to Na-HCO3 hydrofacies). The secondary minerals are typically “black” uranium oxides of mixed oxidation state (e.g. U3O7 and U4O9). For rock U content of 5–50 ppm, it is possible to generate a wide variety of aqueous uranium concentrations, up to a maximum of just over 1 mg L−1, but with typical concentrations of up to 10 μg L−1 for modest degrees of hydrochemical maturity (as indicated by M). These observations correspond extremely well with real groundwater analyses from the Altai-Sayan region of Russia and Norwegian crystalline bedrock aquifers. The timing (with respect to M) and degree of aqueous uranium accumulation are also sensitive to Eh (greater mobilisation at higher Eh), uranium content of rocks (aqueous concentration increases as rock content increases) and PCO2 (low PCO2 favours higher pH, rapid accumulation of aqueous U and earlier saturation with respect to uranium minerals).
|
