Abstract: Investigating the seepage characteristics of the leaching solution in the ore-bearing layer during the in situ leaching process can be useful for designing the process parameters for the uranium mining well. We prepared leaching solutions of four different viscosities and conducted experiments using a self-developed multifunctional uranium ore seepage test device. The effects of different viscosities of leaching solutions on the seepage characteristics of uranium-bearing sandstones were examined using seepage mechanics, physicochemical seepage theory, and dissolution erosion mechanism. Results indicated that while the seepage characteristics of various viscosities of leaching solutions were the same in rock samples with similar internal pore architectures, there were regular differences between the saturated and the unsaturated stages. In addition, the time required for the specimen to reach saturation varied with the viscosity of the leaching solution. The higher the viscosity of the solution, the slower the seepage flow from the unsaturated stage to the saturated stage. Furthermore, during the saturation stage, the seepage pressure of a leaching solution with a high viscosity was greater than that of a leaching solution with a low viscosity. However, the permeability coefficient of the high viscosity leaching solution was less than that of a low viscosity leaching solution.

Abstract: Guideline values are prescribed for drinking water to ensure long term protection of the public against anticipated potential adverse effects. There is a great public and regulatory agencies interest in the guideline values of uranium due to its complex behavior in natural aquatic system and divergent guideline values across the countries. Wide variability in guideline values of uranium in drinking water may be attributed to toxicity reference point, variation in threshold values, uncertainty within intraspecies and interspecies, resource availability, socio-economic condition, variation in ingestion rate, etc. Although guideline values vary to a great extent, reasonable scientific basis and technical judgments are essential before it could be implemented. Globally guideline values are derived considering its radiological or chemical toxicity. Minimal or no adverse effect criterions are normally chosen as the basis for deriving the guideline values of uranium. In India, the drinking water limit of 60 µg/L has been estimated on the premise of its radiological concern. A guideline concentration of 2 µg/L is recommended in Japan while 1700 µg/L in Russia. The relative merit of different experimental assumption, scientific approach and its methodology adopted for derivation of guideline value of uranium in drinking water in India and other countries is discussed in the paper.

Abstract: More than 4,000 sandstone-hosted uranium occurrences host over 1.2 billion pounds of mined and in situ U3O8 throughout the Colorado Plateau. Most of the resources are in two distinct mineral systems with deposits hosted in the Triassic Chinle and Jurassic Morrison Formations. In the Chinle mineral system, base metal sulfides typically accompany mineralization. The Morrison mineral system is characterized by V/U ratios up to 20. The uranium source was likely volcanic ash preserved as bentonitic mudstones in the Brushy Basin Member of the Morrison Formation, and lithic volcanic clasts, ash shards, and bentonitic clay in the lower part of the Chinle Formation. Vanadium originated from two possible sources: iron–titanium oxides that are extensively altered in bleached rock near deposits or from similar minerals in variably bleached red beds interbedded with and beneath the Morrison. In Chinle-hosted deposits, in addition to volcanic ash, a contributing source of both vanadium and uranium is proposed here for the first time to be underlying red beds in the Moenkopi and Cutler Formations that have undergone a cycle of reddening-bleaching-reoxidation. Transport in both systems was likely in groundwater through the more permeable sandstones and conglomerate units. The association of uranium minerals with carbonate and more rarely apatite, suggests that transport of uranium was as a carbonate or phosphate complex. The first comprehensive examination of paleoclimate, paleotopography, and subsurface structure of aquifers coupled with analysis of the geochronology of deposits suggests that that there were distinct pulses of uranium mineralization/redistribution during the period from about 259 Ma to 12 Ma when oxidized mineralizing fluids were intermittently rejuvenated in the Plateau in response to changes in tectonic regime and climate. Multiple lines of evidence indicate that deposits formed at ambient temperatures of about 25 °C to no greater than about 140 °C. In both systems, deposits formed where groundwater flow slowed and was subject to evaporative concentration. Stagnant conditions allowed for prolonged interaction of U- and V-enriched groundwater with ferrous iron-bearing reductants, such as illite and iron–titanium oxides, and more rarely organic material such as plant debris. Paragenetically late in the sequence, reducing fluids introduced additional organic matter to some deposits. Reducing fluids and introduced organic matter (now amorphous and altered by radiolysis) may originate from regional petroleum systems where peak oil and gas generation was from ∼ 82 to ∼ 5 Ma. Our novel analysis indicates that these reducing fluids bleached rock and protected affected deposits from remobilization during exposure and weathering that followed uplift of the Plateau (∼80 to 40 Ma).