|
|
Rubin, R. (1988). Water conservation methods in Israel’s Negev desert in late antiquity. Journal of Historical Geography, 14(3), 229–244.
Abstract: Settlement in Israel’s Negev desert historically has been dependent on water conservation techniques. Fieldwork carried out on settlement sites constructed during the Byzantine period, when agriculture and trade flourished, revealed a variety of water installations some of which are in use today. Perennial springs in the Negev are generally small and difficult of access. Cisterns were the most common conservation devices and came in both large, enclosed and single, open forms. Cisterns were common particularly in the towns, where they were usually built as part of house foundations. Dams were discovered at several sites but proved to be inefficient and easily abandoned because of evaporation and siltation problems. Public reservoirs were part of the structure of the largest towns and were open and among the larges structures uncovered at settlement sites. Wells were distributed widely throughout the desert and were part of the only conservation system that did not depend directly on surface rainfall. A qanat system was located in the eastern Negev dating from the late settlement period before the area was abandoned at the turn of the eighth century. These various water systems raise questions about their builders and their origins, and suggests that builders originating in more humid Mediterranean environments tended to produce less adaptable installations than builders derived from the south or the east.
|
|
|
|
Khoury, H. N., salameh, E. M., & Clark, I. D. (2014). Mineralogy and origin of surficial uranium deposits hosted in travertine and calcrete from central Jordan. Applied Geochemistry, 43, 49–65.
Abstract: Secondary uranium encrustations are hosted in thick travertine and calcrete deposits of Pleistocene–Recent age in central Jordan. The central Jordan varicolored marble and travertine are equivalent to the active metamorphic area in Maqarin, north Jordan. More than 100 samples were collected from the outcrops of the varicolored marble, travertine, calcrete, and the yellow uranium encrustations. The secondary yellow encrustations are mainly composed of uranyl vanadate complexes. Tyuyamunite Ca(UO2)2V25+O8·3(H2O)–strelkinite Na2(UO2)2V2O8·6(H2O) solid solution series are the major components and their composition reflects changes in the Ca/Na ratio in solution. Potentially, new vanadium free calcium uranate phases (restricted to the varicolored marble) were identified with CaO:UO3 ratios different from the known mineral vorlanite (CaU6+)O4. Carbon and oxygen isotope data from calcite in the varicolored marble are characterized by Rayleigh-type enrichment in light isotopes associated with release of 13C and 18O enriched CO2 by high temperature decarbonation during combustion of the bituminous marl. Stable isotope results from uranium hosted travertine and calcrete varieties exhibit a wide range in isotopic values, between decarbonated and normal sedimentary carbonate rocks. The depleted δ13C and δ18O values in the travertine are related to the kinetic reaction of atmospheric CO2 with hyperalkaline Ca(OH)2 water. The gradual enrichment of δ13C and δ18O values in the calcrete towards equilibrium with the surrounding environment is related to continuous evaporation during seasonal dry periods. Uranium mineralization in central Jordan resulted from the interplay of tectonic, climatic, hydrologic, and depositional events. The large distribution of surficial uranium occurrences hosted in travertine and calcrete deposits is related to the artesian ascending groundwater that formed extensive lakes along NNW–SSE trending depressions. Fresh groundwater moved upward through the highly fractured phosphate, bituminous marl and varicolored marble to form unusual highly alkaline water (hydroxide–sulfate type) enriched with sensitive redox elements among which were U and V.
|
|
|
|
Bullock, L. A., & Parnell, J. (2017). Selenium and molybdenum enrichment in uranium roll-front deposits of Wyoming and Colorado, USA. Journal of Geochemical Exploration, 180, 101–112.
Abstract: Sandstone uranium (U) roll-front deposits of Wyoming and Colorado (USA) are important U resources, and may provide a terrestrial source for critical accessory elements, such as selenium (Se), molybdenum (Mo), and tellurium (Te). Due to their associated toxicity, MoSeTe occurrences in roll-fronts should also be carefully monitored during U leaching and ore processing. While elevated MoSe concentrations in roll-fronts are well established, very little is known about Te occurrence in such deposits. This study aims to establish MoSeTe concentrations in Wyoming and Colorado roll-fronts, and assess the significance of these deposits in an environmental and mineral exploration context. Sampled roll-front deposits, produced by oxidized groundwater transportation through a sandstone, show high MoSe content in specific redox zones, and low Te, relative to crustal means. High Se concentrations (up to 168ppm) are restricted to a narrow band of alteration at the redox front. High Mo content (up to 115ppm) is typically associated with the reduced mineralized nose and seepage zones of the roll-front, ahead of the U orebody. Elevated trace element concentrations are likely sourced from proximal granitic intrusions, tuffaceous deposits, and local pyritic mudstones. Elevated MoSe content in the sampled roll fronts may be regarded as a contaminant in U in-situ recovery and leaching processing, and may pose an environmental threat in groundwaters and soils, so extraction should be carefully monitored. The identification of peak concentrations of MoSe can also act as a pathfinder for the redox front of a roll-front, and help to isolate the U orebody, particularly in the absence of gamma signatures.
|
|
|
|
Li, X., Shen, K., Li, Q., Deng, Y., Zhu, P., & Wang, D. (2018). Roll-over behavior in current-voltage curve introduced by an energy barrier at the front contact in thin film CdTe solar cell. Solar Energy, 165, 27–34.
Abstract: Roll-over phenomenon in the current–voltage (J–V) curve is often observed in a CdTe thin film solar cell. The roll-over phenomenon, which is occurred near the open-circuit voltage in a light J–V curve, is due to Schottky energy barrier formed at the CdTe/metal interface in a CdTe solar cell back contact. In this study we report a J–V roll-over phenomenon which is induced by an energy barrier at the front contact of a CdTe solar cell. Two kinds of oxides, namely, Al2O3 and SnO2, were deposited as high-resistance transparent (HRT) layer between the window layer CdS and the fluorine doped tin oxide (FTO) front electrode in CdTe solar cells. These two oxides present much different electronic band alignment with FTO and CdS. SnO2 formed almost no energy barrier with CdS, this allowed smooth transport for photo-generated electrons from CdTe to CdS and FTO. However, Al2O3 formed a high energy barrier with CdS. The rather high energy barrier with a value of 3.43 eV at the CdS/Al2O3 interface induced a J–V roll-over phenomenon in a CdTe thin film solar cell, which dramatically led to a quick decrease for the cell device efficiency. The electron transport at the FTO/Al2O3/CdS interface is governed by tunneling effect. The results presented in this study demonstrate that the band structure at the front electrode plays an important role for the performance of a CdTe thin film solar cell.
|
|
|
|
Rehm-Berbenni, C., Druta A., Åberg, G., Neguer J., Külls, C., Patrizi, G., et al. (2005). Isotope Technologies Applied to the Analysis of Ancient Roman Mortars.
Abstract: Results of the CRAFT Project EVK4 CT-2001-30004
|
|
