Abstract: In-situ leaching (ISL) is a chemical method for recovering useful minerals and metals directly from underground ore bodies which is also referred to as ‘solution mining’. ISL is commonly used for uranium mining, accounting for about 45% of global production. The main benefits are claimed to be a lower environmental impact in terms of visual disturbances, emissions, lower energy use, cost compared with conventional open-cut or underground mining methods, and potential utilisation of lower grade resources. However, there is a lack of reported studies on the assessment of the environmental impacts of ISL, particularly greenhouse gas (GHG) emissions using life cycle assessment (LCA) methodology. The SimaPro LCA software was used to estimate the GHG footprint of the ISL of uranium, gold and copper. The total GHG emissions were estimated to be 38.0 kg CO2-e/kg U3O8 concentrate (yellowcake), 29 t CO2-e/kg gold, and 4.78 kg CO2-e/kg Cu. The GHG footprint of ISL uranium was significantly lower than that of conventional mining, however, the footprints of copper and gold were not much less compared with conventional mining methods. This is due to the lower ore grade of ISL deposits and recovery compared with high ore grades and recovery of conventional technology. Additionally, the use of large amount of electricity for pumping in case of ISL contributes to this result. The electricity consumed in pumping leaching solutions was by far the greatest contributor to the well-field related activities associated with ISL of uranium, gold and copper. The main strategy to reduce the GHG footprint of ISL mining should be to use electricity derived from low emission sources. In particular, renewable sources such as solar would be suitable for ISL as these operations are typically in remote locations with smaller deposits compared with conventional mining sites.

Abstract: The migration process of leached uranium in the in-situ leaching of uranium is considered a typical reactive transport problem. During this process, the lixiviant concentration and injection rate are important in-situ leaching process parameters (ISLPP) to efficiently recover uranium. However, several uncertain factors affect the outcomes of the ISLPP design. In addition, the repeated use of the reactive transport model (RTM) for investigating the acid in-situ leaching of uranium with the application of the Monte Carlo method leads to a substantial computational load. For this reason, a machine learning (ML)–based surrogate model was developed with the backpropagation neural network (BPNN) method to replace the RTM under the condition of uncertain parameters. Moreover, the simulated annealing optimisation model for ISLPP was created based on the proposed surrogate model. The optimal ISLPP was achieved that generated maximum profits from uranium recovery under different lixiviant prices, uranium prices and exploitation times. The optimal design framework of ISLPP based on the proposed ML algorithm was then applied in the Bayan-Uul sandstone-type uranium deposit in Inner Mongolia, China. From our analysis, it was demonstrated that the ML-based surrogate model exhibited great fitness with the RTM. The optimal results of the ISLPP indicated that the lixiviant concentration and injection rate could be adjusted based on the fluctuations in lixiviant price, uranium price and exploitation time. If the prices of sulphuric acid were high, a specific concentration of hydrogen peroxide could be injected into the injection well to promote the oxidation and dissolution of the uranium ore to increase the income from the uranium recovery. The optimisation model can also use the ISLPP scheme to boost the revenues from different lixiviant prices, uranium prices and exploitation times under the uncertainty of porosity, illustrating the applicability of the ML-based optimal design method of ISLPP in ISL mining. A general framework for developing surrogate models, as well as for conducting uncertainty analyses for a wide range of groundwater models was proposed here yielding valuable insights.

Abstract: 81Kr and 36Cl can both be used to date groundwater beyond the dating range of 14C. 81Kr usually provides reliable groundwater ages because it has uniform initial distribution and negligible subsurface generation, while 36Cl is commonly influenced by subsurface sources or “dead” chloride dissolution. Therefore, the combined use of 81Kr and 36Cl could provide clues on the evolution history of groundwater. In the present study, we performed 36Cl and 81Kr dating of geothermal water in Weihe Basin of China and interpreted the possible cause of disagreement. Two distinct water masses were identified with distinctive isotopic signals: groundwater with significant δ18O shifts (up to −2.0‰), dissolved dead Cl and ages < 1.0 Ma (Cluster A), and older water with little δ18O shifts, negligible dissolved Cl and ages >1.0 Ma (Cluster B). The results confirm the eastward flow path of Cluster B to the Ancient Sanmen Lake with an increasing trend of Cl concentration and age. Modern recharge from the mountains flows to the basin center with intense interaction between water and carbonate under respective reservoir temperatures (100 ∼ 130 °C). These waters flow through the saline stratum emerging from the spillover of the Ancient Sanmen Lake, resulting in higher dead Cl dissolution. A significant linear relationship is observed with the older end-member of ∼1.3Ma under the topographically-driven faster circulation effect. 81Kr ages seem to support the hypothesis that the birth of the modern Yellow River was at about 1.0–1.3 Ma. We inferred the drainage reorganization from the Ancient Sanmen Lake to the modern Yellow River since the Mid-Pleistocene Transition induced the change in groundwater dynamics as well as its chemical evolution. The excavation of the Ancient Sanmen Lake and the accentuated incision of the Weihe River induced groundwater gradient, and therefore the recharge from precipitation from both slopes of the Qinling Mountains in the south and the Beishan Mountains in the north. Our results highlight the effects of dead Cl on 36Cl dating and demonstrate the significant impact of catchment reorganization on groundwater dynamics and its chemistry.

Abstract: The long-lived radio-krypton isotope 81Kr (t1/2 = 2.29 × 105 yr) is an ideal tracer for old groundwater age dating in the range of 105–106 years which goes beyond the reach of radio-carbon (14C) age dating. Analytical breakthrough made over the last two decades in Atom Trap Trace Analysis (ATTA) has enabled the use of this isotope with extremely low abundance (81Kr/Kr = 6 × 10−13) to be used as a practical dating tool for very old groundwater. The International Atomic Energy Agency aims to provide this new isotope tool for better groundwater resource management of Member States and developed a field sampling device to collect dissolved gas samples from groundwater and a system to separate and purify trace amounts of krypton from the gas samples for the ATTA analysis. The design, setup and performances of our sampling and purification systems are described here. Our system can produce a high purity aliquot of about 5 μL of krypton from 5 L of air sample (recovery yield of >90%). The samples made by our system were confirmed to be acceptable for the ATTA analysis.

Abstract: A complete hydrogeological understanding of the deep Upper Jurassic carbonate aquifer in the South German Molasse Basin is essential for the future development of this important drinking water resource and geothermally used system. Water chemistry data, δ13CDIC, 14C of the dissolved inorganic carbon (14CDIC) and stable water isotope (δ18O and δD) measurements have been used to evaluate a promising groundwater dating approach with 14C of dissolved organic carbon (14CDOC). The pre-concentration of dissolved organic matter (DOM) was performed by the easy applicable solid phase extraction (SPE) with a styrene-divinylbenzene copolymer sorbent (PPL). Based on the sampling campaign of seven groundwater wells conducted between 2017 and 2019, it was shown that the groundwater is mainly of Ca–HCO3 type with some evidence of ion exchange between Ca2+ and Na+ at two of the investigated wells. The δD values ranged from −89.4‰ to −70.9‰ while δ18O values varied between −12.5‰ and −9.8‰. The obtained stable water isotope signatures indicated that the groundwater is of meteoric origin and was recharged during warm climate (Holocene), intermediate climate and cold climate (Pleistocene) infiltration conditions. The measured 14CDOC activities varied from 5.7 pmC to 51.1 pmC and the calculated piston-flow water ages (ORAs) ranged from 4200 years to 25,248 years using an initial 14C0DOC of 85 pmC. The calculated ORAs showed a very good correlation to the infiltration temperature-sensitive δ18O values which were affirmed with noble gas infiltration temperatures for two wells after Weise et al. (1991) and were also in good accordance with the atmospheric temperature record of the northern hemisphere from Dokken et al. (2015). The results reflect a consistent hydrogeological picture of the carbonate aquifer, which also supports the applicability of the SPE-PPL method for 14CDOC dating in groundwater with a low DOC content (<1 mg/l). In contrast, 14CDIC activities of 1.4 pmC to 21.3 pmC led to geochemically corrected piston-flow ages between 8057 years and >30,000 years and generally to an overestimation of the apparent water ages. This study gives insights into the promising approach of 14CDOC groundwater dating in carbonate aquifers with low DOC contents and allows future sustainable groundwater resource management of the investigated aquifer system.