Abstract: Drawing on advances in nonstationary frequency analysis and the science of causation and attribution, this study employs a newly developed nonstationary stochastic paired watershed approach to determine the effect of forest harvesting on snowmelt-generated floods. Moreover, this study furthers the application of stochastic physics to evaluate the environmental controls and drivers of flood response. Physically-based climate and time-varying harvesting data are used as covariates to drive the nonstationary flood frequency distribution parameters to detect, attribute, and quantify the effect of harvesting on floods in the snow-dominated Deadman River (878 km2) and nested Joe Ross Creek (99 km2) watersheds. Harvesting only 21% of the watershed caused a 38% and 84% increase in the mean but no increase in variability around the mean of the frequency distribution in the Deadman River and Joe Ross Creek, respectively. Consequently, the 7-year, 20-year, 50-year, and 100-year flood events became approximately two, four, six, and ten times more frequent in both watersheds. An increase in the mean is posited to occur from an increase in moisture availability following harvest from suppressed snow interception and increased net radiation reaching the snowpack. Variability was not increased because snowmelt synchronization was inhibited by the buffering capacity of abundant lakes, evenly distributed aspects, and widespread spatial distribution of cutblocks in the watersheds, preventing any potential for harvesting to increase the efficiency of runoff delivery to the outlet. Consistent with similar recent studies, the effect of logging on floods is controlled not only by the harvest rate but most importantly the physiographic characteristics of the watershed and the spatial distribution of the cutblocks. Imposed by the probabilistic framework to understanding and predicting the relation between extremes and their environmental controls, commonly used in the general sciences but not forest hydrology, it is the inherent nature of snowmelt-driven flood regimes which cause even modest increases in magnitude, especially in the upper tail of the distribution, to translate into surprisingly large changes in frequency. Contrary to conventional wisdom, harvesting influenced small, medium, and very large flood events, and the sensitivity to harvest increased with increasing flood event size and watershed area.

Abstract: It is well known that rainwater harvesting (RWH) can augment water supply and reduce stormwater pollutant discharges. Due to the lack of continuous 2D modelling of urban flood coverage and its associated damage, the ability of RWH to reduce urban flood risks has not been fully evaluated. Literature suggests that small distributed storage spaces using RWH tanks will reduce flood damage only during small to medium flooding events and therefore cumulative assessment of their benefits is needed. In this study we developed a new integrated modelling framework that implements a semi-continuous simulation approach to investigate flood prevention and water supply benefits of RWH tanks. The framework includes a continuous mass balance simulation model that considers antecedent rainfall conditions and water demand/usage of tanks and predicts the available storage prior to each storm event. To do so, this model couples a rainfall-runoff tank storage model with a detailed stochastic end-use water demand model. The available storage capacity of tanks is then used as a boundary condition for the novel rapid flood simulation model. This flood model was developed by coupling the U.S. EPA Storm Water Management Model (SWMM) to the Cellular-Automata Fast Flood Evaluation (CA-ffé) model to predict the inundation depth caused by surcharges over the capacity of the drainage network. The stage-depth damage curves method was used to calculate time series of flood damage, which are then directly used for flood risk and cost-benefit analysis. The model was tested through a case study in Melbourne, using a recorded rainfall time series of 85 years (after validating the flood model against 1D-2D MIKE-FLOOD). Results showed that extensive implementation of RWH tanks in the study area is economically feasible and can reduce expected annual damage in the catchment by up to approximately 30 percent. Availability of storage space and temporal distribution of rainfall within an event were important factors affecting tank performance for flood reduction.