Abstract: The factors influencing uranium recovery in water-rock systems during acid in-situ leaching (ISL) were studied at the Kujieertai uranium deposit in Xinjiang. Using an ISL unit, a field leach trial (FLT) had been carried out to test the sequential effects of a leaching solution without oxidant (H2SO4 solution 4–8 g/L) and a leaching solution with oxidant (H2SO4 3–7 g/L, and Fe (III) 2–6 g/L). The observation of the leaching process revealed clearly defined stages of uranium release from the solid mineral to solution. Uranium mobilization from solid mineral into solution can be described in four stages. At the beginning of the acid ISL process, there was no oxidant to be added to the leaching solution and the desorption of hexavalent uranyl ions in the open pores, as well as dissolution of hexavalent uranium minerals, led to a short-term peak in the pregnant solution, which happened while pH decreased from about 5.3 to 2.62. Following the depletion of the adsorbed hexavalent uranium and a decline in uranium dissolution intensity, the addition of Fe(III) facilitated the oxidation of tetravalent uranium, which enabled intensive uranium mobilization again. During this process, the dissolution of uranium had a strong positive correlation with the reduction of Fe(III) and Eh in the leach solution. Beside hydrochemical factors, the deportment of uranium was also an important factor affecting uranium recovery. Uranium located in the open pores can be completely exposed to the solution and the mobilization intensity was significantly affected by hydrogeochemical conditions; but the uranium present in microfissures and in the ore matrix could not be fully exposed to the solution, so, their dissolution intensity was primarily controlled by corrosion and permeability of the ore. In general, the hydrogeochemical conditions and the deportment of uranium were the external and internal factors that significantly affected the dissolution and recovery of uranium in the early and middle stages of the FLT. However, in the latest stages, due to uranium depletion, enhancing the chemical potential of the leaching solution, specifically acidity and/or the amount of oxidant, had little improvement on uranium recovery.

Abstract: Conventional continental geoarchives are rarely available in arid southern Africa. Therefore, palaeoclimate data in this area are still patchy and late Quaternary climate development is only poorly understood. In the western Kalahari, salt pans (playas, ephemeral lakes) are common and can feature quasi-continuous sedimentation. This study presents the first climate-related biomarker record using sediments from the Omongwa Pan, a Kalahari salt pan located in eastern Namibia. Our approach to reconstruct vegetation and hydrology focuses on biogeochemical bulk parameters and plant wax-derived lipid biomarkers (n-alkanes, n-alkanols, and fatty acids) and their compound-specific carbon and hydrogen isotopic compositions. The presented record reaches back to 27 ka. During the glacial, rather low δ2H values of n-alkanes and low sediment input exclude a strong influence of winter rainfall. n-Alkane and n-alkanol distributions and δ13C values of n-hentriacontane (n-C31) indicate a shift to a vegetation with a higher proportion of C4 plants at the end of the Last Glacial Maximum until the end of Heinrich Stadial I (ca. 18–14.8 ka), which we interpret to indicate an abrupt excursion to a short wetter period likely to be caused by a temporary southward shift of the Intertropical Convergence Zone. Shifts in δ2H values of n-C31 and plant wax parameters give evidence for changes to drier conditions during early Holocene. Comparison of this dataset with representative continental records from the region points to a major influence of summer rainfall at Omongwa Pan during the regarded time span and demonstrates the potential of southern African salt pans as archives for biomarker-based climate proxies.

Abstract: It is well known that rainwater harvesting (RWH) can augment water supply and reduce stormwater pollutant discharges. Due to the lack of continuous 2D modelling of urban flood coverage and its associated damage, the ability of RWH to reduce urban flood risks has not been fully evaluated. Literature suggests that small distributed storage spaces using RWH tanks will reduce flood damage only during small to medium flooding events and therefore cumulative assessment of their benefits is needed. In this study we developed a new integrated modelling framework that implements a semi-continuous simulation approach to investigate flood prevention and water supply benefits of RWH tanks. The framework includes a continuous mass balance simulation model that considers antecedent rainfall conditions and water demand/usage of tanks and predicts the available storage prior to each storm event. To do so, this model couples a rainfall-runoff tank storage model with a detailed stochastic end-use water demand model. The available storage capacity of tanks is then used as a boundary condition for the novel rapid flood simulation model. This flood model was developed by coupling the U.S. EPA Storm Water Management Model (SWMM) to the Cellular-Automata Fast Flood Evaluation (CA-ffé) model to predict the inundation depth caused by surcharges over the capacity of the drainage network. The stage-depth damage curves method was used to calculate time series of flood damage, which are then directly used for flood risk and cost-benefit analysis. The model was tested through a case study in Melbourne, using a recorded rainfall time series of 85 years (after validating the flood model against 1D-2D MIKE-FLOOD). Results showed that extensive implementation of RWH tanks in the study area is economically feasible and can reduce expected annual damage in the catchment by up to approximately 30 percent. Availability of storage space and temporal distribution of rainfall within an event were important factors affecting tank performance for flood reduction.