Akter, A., Tanim, A. H., & Islam, M. K. (2020). Possibilities of urban flood reduction through distributed-scale rainwater harvesting. Water Science and Engineering, 13(2), 95–105.
Abstract: Urban flooding in Chittagong City usually occurs during the monsoon season and a rainwater harvesting (RWH) system can be used as a remedial measure. This study examines the feasibility of rain barrel RWH system at a distributed scale within an urbanized area located in the northwestern part of Chittagong City that experiences flash flooding on a regular basis. For flood modeling, the storm water management model (SWMM) was employed with rain barrel low-impact development (LID) as a flood reduction measure. The Hydrologic Engineering Center’s River Analysis System (HEC-RAS) inundation model was coupled with SWMM to observe the detailed and spatial extent of flood reduction. Compared to SWMM simulated floods, the simulated inundation depth using remote sensing data and the HEC-RAS showed a reasonable match, i.e., the correlation coefficients were found to be 0.70 and 0.98, respectively. Finally, using LID, i.e., RWH, a reduction of 28.66% could be achieved for reducing flood extent. Moreover, the study showed that 10%–60% imperviousness of the subcatchment area can yield a monthly RWH potential of 0.04–0.45 m3 from a square meter of rooftop area. The model can be used for necessary decision making for flood reduction and to establish a distributed RWH system in the study area.
|
Pereira, A. J. S. C., & Neves, L. J. P. F. (2012). Estimation of the radiological background and dose assessment in areas with naturally occurring uranium geochemical anomalies—a case study in the Iberian Massif (Central Portugal). Journal of Environmental Radioactivity, 112, 96–107.
Abstract: Naturally occurring uranium geochemical anomalies, representative of the several thousand recognized in the Portuguese section of the Iberian Massif and outcropping in three target areas with a total of a few thousand square metres, were subjected to a detailed study (1:1000 scale) to evaluate the radiological health-risk on the basis of a dose assessment. To reach this goal some radioactive isotopes from the uranium, thorium and potassium radioactive series were measured in 52 samples taken from different environmental compartments: soils, stream sediments, water, foodstuff (vegetables) and air; external radiation was also measured through a square grid of 10×10m, with a total of 336 measurements. The results show that some radioisotopes have high activities in all the environmental compartments as well as a large variability, namely for those of the uranium decay chain, which is a common situation in the regional geological setting. Isotopic disequilibrium is also common and led to an enrichment of several isotopes in the different pathways, as is the case of 226Ra; maximum values of 1.76BqL−1 (water), 986Bqkg−1 (soils) and 18.9Bqkg−1 (in a turnip sample) were measured. On the basis of a realistic scenario combined with the experimental data, the effective dose from exposure to ionizing radiation for two groups of the population (rural and urban) was calculated; the effective dose is variable between 8.0 and 9.5mSvyear−1, which is 3–4 times higher than the world average. Thus, the radiological health-risk for these populations could be significant and the studied uranium anomalies must be taken into account in the assessment of the geochemical background. The estimated effective dose can also be used as typical of the background of the Beiras uranium metalogenetic province and therefore as a “benchmark” in the remediation of the old uranium mining sites.
|
|
Demuth, S., & Külls, C. (1997). Probability analysis and regional aspects of droughts in southern Germany. Sustainability of Water Resources under Increasing Uncertainty, (240), 97.
|
Tan, K., Li, C., Liu, J., Qu, H., Xia, L., Hu, Y., et al. (2014). A novel method using a complex surfactant for in-situ leaching of low permeable sandstone uranium deposits. Hydrometallurgy, 150, 99–106.
Abstract: Applications of a complex surfactant developed in-house to in-situ leaching of low permeable sandstone uranium deposits are described based on results from agitation leaching, column leaching, resin adsorption, and elution experiments using uranium containing solution from the in-situ leaching site. The results of agitation leaching experiments show that adding surfactant with different concentrations into leaching solution improves the leaching rate of uranium. The maximum leaching rate of uranium from agitation leaching reached 92.6% at an added surfactant concentration of 10mg/l. Result of column leaching experiment shows that adding surfactant with varying concentrations into leaching solutions increased the permeability coefficient of ore-bearing layer by 42.7–86.8%. The leaching rate of uranium from column leaching increased by 58.0% and reached 85.8%. The result of kinetic analysis shows that for the extraction of uranium controlled by diffusion without surfactant the apparent rate constant 0.0023/d changed to 0.0077/d for the extraction with surfactant controlled by both diffusion and surface chemical reactions. Results from resin adsorption and elution experiments show that there was no influence on resin adsorption and elution of uranium with an addition of 50mg/l surfactant to production solution from in-situ leaching. The adsorption curve, sorption capacity of resin, recycling of resin remained the same as without adding any surfactant. Introducing complex surfactant to leaching solution increased the peak concentration of uranium in eluents, reduced the residual uranium content in resin, and promoted the elution efficiency. The method of using a complex surfactant for in-situ leaching is useful for low permeable sandstone uranium deposits.
|
Bullock, L. A., & Parnell, J. (2017). Selenium and molybdenum enrichment in uranium roll-front deposits of Wyoming and Colorado, USA. Journal of Geochemical Exploration, 180, 101–112.
Abstract: Sandstone uranium (U) roll-front deposits of Wyoming and Colorado (USA) are important U resources, and may provide a terrestrial source for critical accessory elements, such as selenium (Se), molybdenum (Mo), and tellurium (Te). Due to their associated toxicity, MoSeTe occurrences in roll-fronts should also be carefully monitored during U leaching and ore processing. While elevated MoSe concentrations in roll-fronts are well established, very little is known about Te occurrence in such deposits. This study aims to establish MoSeTe concentrations in Wyoming and Colorado roll-fronts, and assess the significance of these deposits in an environmental and mineral exploration context. Sampled roll-front deposits, produced by oxidized groundwater transportation through a sandstone, show high MoSe content in specific redox zones, and low Te, relative to crustal means. High Se concentrations (up to 168ppm) are restricted to a narrow band of alteration at the redox front. High Mo content (up to 115ppm) is typically associated with the reduced mineralized nose and seepage zones of the roll-front, ahead of the U orebody. Elevated trace element concentrations are likely sourced from proximal granitic intrusions, tuffaceous deposits, and local pyritic mudstones. Elevated MoSe content in the sampled roll fronts may be regarded as a contaminant in U in-situ recovery and leaching processing, and may pose an environmental threat in groundwaters and soils, so extraction should be carefully monitored. The identification of peak concentrations of MoSe can also act as a pathfinder for the redox front of a roll-front, and help to isolate the U orebody, particularly in the absence of gamma signatures.
|
