| Home | << 1 2 3 4 5 6 >> |
|
Christofi, C., Bruggeman, A., Külls, C., & Constantinou, C. (2020). Isotope hydrology and hydrogeochemical modeling of Troodos Fractured Aquifer, Cyprus: The development of hydrogeological descriptions of observed water types. Applied Geochemistry, 123, 104780.
Abstract: The origin of groundwater recharge and subsequent flow paths are often difficult to establish in fractured, multi-lithological, and highly compartmentalized aquifers such as the Troodos Fractured Aquifer (TFA). As the conjunctive use of stable isotopes and hydrogeochemical data provides additional information, we established a monitoring network for stable isotopes in precipitation in Cyprus. The local meteoric water line, altitude effect and seasonal variation of stable isotopes in precipitation are derived from monitoring data. Stable isotopes and hydrogeochemical data are combined to model water-rock interactions and groundwater evolution along a complete ophiolite sequence. As a result a generic hydrogeologic description for the observed water types is developed. Isotope hydrology was applied in conjunction with hydrogeochemical modelling in Kargiotis Watershed, a major north-south transect of the TFA. PHREEQC was used for hydrogeochemical modelling to establish generic descriptions for observed water types. Mean precipitation-weighted values from 16 monitoring stations were used to calculate the Local Meteoric Water Line (LMWL), which was found to be equal to δ2H = (6.58 ± 0.13)*δ18O + (12.64 ± 0.91). A general decrease of 1.22‰ for δ2H and 0.20‰ for δ18O in precipitation was calculated per 100 m altitude. A generic groundwater evolution path was established: 1. Na/MgClHCO3, 2. MgHCO3, 3. Ca/MgHCO3, 4. Ca/MgNaHCO3, 4a. MgNa/CaHCO3/Cl, 5. NaMg/CaHCO3/Cl, 6. NaHCO3, 7. Na/MgHCO3SO4, 8. NaSO4Cl/HCO3. Hydrogeologic descriptions, consisting of groundwater origin, flow path and possible active water-rock processes, have been realised for the observed water types. The first two water types occur in serpentine and ultramafic-gabbro springs. Type 3 waters represent early stages of recharge and/or short flow paths, in gabbro whereas types 4 and 5 are typical for further percolating waters in gabbro and diabase. Water types 6 and 7 occur both in diabase and in the basal group and represent the regional flow. Water type 8 is the end member of regional, upwelling groundwater in the basal group. The presented descriptions and methods have practical applications in groundwater exploration, characterization, and protection. The methodology can be applied in other complex aquifer systems.
Area: Cyprus
|
|
Gardiner, J., Thomas, R. B., Phan, T. T., Stuckman, M., Wang, J., Small, M., et al. (2020). Utilization of produced water baseline as a groundwater monitoring tool at a CO2-EOR site in the Permian Basin, Texas, USA. Applied Geochemistry, 121, 104688.
Abstract: Carbon dioxide (CO2) enhanced oil recovery (EOR) provides a pathway for economic reuse and storage of CO2, a greenhouse gas. One challenge with this practice is ensuring CO2 injection does not result in target reservoir fluids migrating into overlying shallow (\textless1000 m) groundwater formations. Effective monitoring for leakage from storage formations could involve measuring sensitive chemical indicators in overlying groundwater units and within the producing formation itself for evidence of deviation from an initial state. In this study, produced waters and overlying groundwaters were monitored over a five-year period to evaluate which geochemical signals may be useful to ensure that oilfield produced waters did not impact overlying groundwaters. During this five-year period, a mature carbonate oil reservoir in the Permian Basin transitioned from a waterflooding operation to a water-alternating-gas injection (WAG), in which the formation was flooded with CO2 and various mixtures of produced water. Significant increases in dissolved inorganic constituents [alkalinity, TDS, Na+, Cl−, SO42−] were observed in produced waters following CO2 injection; however, carbonate reservoir dissolution-precipitation reactions appear to be minimal and injected CO2 appears to be stored via solubility trapping. Although there are statistically significant geochemical variations following CO2 injection, applying isometric log-ratios to certain parameters establishes a narrow range for post-CO2 injection produced waters. This narrow range can be considered a baseline for post-CO2 injection produced waters; this baseline can be utilized to monitor overlying local groundwaters for produced water intrusion. Additionally, certain parameters [Na+, Ca2+, K+, Cl−, alkalinity, and TDS] display large concentration disparities between produced water and overlying groundwaters; these parameters would be sensitive indicators of produced water intrusion into overlying groundwaters.
|
|
Zhou, Y., Li, G., Xu, L., Liu, J., Sun, Z., & Shi, W. (2020). Uranium recovery from sandstone-type uranium deposit by acid in-situ leaching – an example from the Kujieertai. Hydrometallurgy, 191, 105209.
Abstract: The factors influencing uranium recovery in water-rock systems during acid in-situ leaching (ISL) were studied at the Kujieertai uranium deposit in Xinjiang. Using an ISL unit, a field leach trial (FLT) had been carried out to test the sequential effects of a leaching solution without oxidant (H2SO4 solution 4–8 g/L) and a leaching solution with oxidant (H2SO4 3–7 g/L, and Fe (III) 2–6 g/L). The observation of the leaching process revealed clearly defined stages of uranium release from the solid mineral to solution. Uranium mobilization from solid mineral into solution can be described in four stages. At the beginning of the acid ISL process, there was no oxidant to be added to the leaching solution and the desorption of hexavalent uranyl ions in the open pores, as well as dissolution of hexavalent uranium minerals, led to a short-term peak in the pregnant solution, which happened while pH decreased from about 5.3 to 2.62. Following the depletion of the adsorbed hexavalent uranium and a decline in uranium dissolution intensity, the addition of Fe(III) facilitated the oxidation of tetravalent uranium, which enabled intensive uranium mobilization again. During this process, the dissolution of uranium had a strong positive correlation with the reduction of Fe(III) and Eh in the leach solution. Beside hydrochemical factors, the deportment of uranium was also an important factor affecting uranium recovery. Uranium located in the open pores can be completely exposed to the solution and the mobilization intensity was significantly affected by hydrogeochemical conditions; but the uranium present in microfissures and in the ore matrix could not be fully exposed to the solution, so, their dissolution intensity was primarily controlled by corrosion and permeability of the ore. In general, the hydrogeochemical conditions and the deportment of uranium were the external and internal factors that significantly affected the dissolution and recovery of uranium in the early and middle stages of the FLT. However, in the latest stages, due to uranium depletion, enhancing the chemical potential of the leaching solution, specifically acidity and/or the amount of oxidant, had little improvement on uranium recovery.
|
|
Pree, T. A. D. (2020). The politics of baselining in the Grants uranium mining district of northwestern New Mexico. Journal of Environmental Management, 268, 110601.
Abstract: During the second half of the twentieth century, northwestern New Mexico served as the primary production site for one of the world’s largest nuclear arsenals. From 1948 to 1970 the “Grants uranium district” provided almost half of the total uranium ore accumulated by the United States federal government for the production of nuclear weapons, in addition to becoming a national source for commercial nuclear energy from the late 1960s to the early 1990s. By the twenty-first century, after a prolonged period of economic decline that began in the late 1970s, all uranium mining and milling in New Mexico had ceased, leaving a legacy of environmental health impacts. What was once referred to as “The Uranium Capital of the World” now encompasses over a thousand abandoned uranium mines and seven massive uranium mill tailings piles, which are associated with airborne and soil contamination as well as groundwater plumes of uranium and other contaminants of concern, in a landscape that has been fractured by underground mine workings and punctured by thousands of exploratory boreholes. This article presents an ethnographic study of the diverse forms of expertise involved in monitoring and managing the mine waste and mill tailings. Drawing from over two years of ethnographic research, I describe the relationship between different stakeholders from local communities, government agencies, and transnational mining corporations as they deliberate about the possibility of cleaning up the former mining district. My thesis is that the possibility of cleaning up the Grants district hinges on the “politics of baselining”—a term I introduce to describe the relationship between stakeholders and their competing environmental models and hydrogeological theories; each accounts for a different geological past prior to mining that can be deemed “natural,” as the background against which to measure the anthropogenic impacts from mining.
|
|
Su, X., Liu, Z., Yao, Y., & Du, Z. (2020). Petrology, mineralogy, and ore leaching of sandstone-hosted uranium deposits in the Ordos Basin, North China. Ore Geology Reviews, 127, 103768.
Abstract: The Nalinggou–Daying uranium metallogenic belt is situated at the northern Ordos Basin, China. Petrographical, mineralogical and geochemical techniques were used to study the ore-bearing sandstones and host rocks in the Nalinggou–Daying uranium metallogenic belt. The present study shows that uranium minerals, i.e., coffinite, pitchblende, and brannerite, are mostly disseminated around pyrite and detrital particles. The ore-bearing sandstones are enriched in organic matter, with which this reductive environment influenced uranium leaching. The carbonate concentration of the uranium ores is markedly higher than that of the host rocks, and intense carbonatization occurs in the ore-bearing sandstones. In this case, the usage of the classical in-situ leach uranium mining technique by injecting H2SO4 + H2O2 solution produces calcium sulfate precipitate, which can lead to blocking of the ore-bearing strata. For this reason, laboratory and field uranium mining tests were conducted using CO2 + O2 in-situ leaching technology and were demonstrated to be successful, illustrating that this approach is technically feasible. Inhibiting ore bed blockage and increasing the amount of injected O2 are important for uranium leaching in this setting.
|