|
|
Robati, A., & Barani, G. A. (2009). Modeling of water surface profile in subterranean channel by differential quadrature method (DQM). Applied Mathematical Modelling, 33(3), 1295–1305.
Abstract: This study, investigates the hydraulic of flow in a subterranean channel headspring. The continuity and momentum equations of flow in porous media considering real conditions were used and the basic equation of flow in a subterranean channel was resulted. This equation is very similar to the spatially varied flow with increasing discharge. An equation, defining the hydraulic parameters of a subterranean channel section was adopted. Then differential quadrature method (DQM), was applied to the equation of flow in subterranean channel, consequently the water surface profile was resulted. To illustrate the rightness of model, the hydraulic parameters of flow in the Gavgard branch of the Joopar Goharriz Qanat were measured and the water surface profile was determined. This water surface profile was compared to the water surface profile computed by the model, which are in good agreement.
|
|
|
|
Rubin, R. (1988). Water conservation methods in Israel’s Negev desert in late antiquity. Journal of Historical Geography, 14(3), 229–244.
Abstract: Settlement in Israel’s Negev desert historically has been dependent on water conservation techniques. Fieldwork carried out on settlement sites constructed during the Byzantine period, when agriculture and trade flourished, revealed a variety of water installations some of which are in use today. Perennial springs in the Negev are generally small and difficult of access. Cisterns were the most common conservation devices and came in both large, enclosed and single, open forms. Cisterns were common particularly in the towns, where they were usually built as part of house foundations. Dams were discovered at several sites but proved to be inefficient and easily abandoned because of evaporation and siltation problems. Public reservoirs were part of the structure of the largest towns and were open and among the larges structures uncovered at settlement sites. Wells were distributed widely throughout the desert and were part of the only conservation system that did not depend directly on surface rainfall. A qanat system was located in the eastern Negev dating from the late settlement period before the area was abandoned at the turn of the eighth century. These various water systems raise questions about their builders and their origins, and suggests that builders originating in more humid Mediterranean environments tended to produce less adaptable installations than builders derived from the south or the east.
|
|
|
|
Kurmanseiit, M. B., Tungatarova, M. S., Royer, J. - J., Aizhulov, D. Y., Shayakhmetov, N. M., & Kaltayev, A. (2023). Streamline-based reactive transport modeling of uranium mining during in-situ leaching: Advantages and drawbacks. Hydrometallurgy, 220, 106107.
Abstract: Reactive transport modeling is known to be computationally intensive when applied to 3D problems. Transforming sequential computing on the computer processor units (CPU) into parallelized computation on the high-performance parallel graphic processor units (GPU) is a classical approach to increasing computational performance. Another complementary approach is to decompose a complex 3D modeling problem into a set of simpler 1D problems using streamline approaches which can be easily parallelized, therefore reducing computation time. This paper investigates solutions to the equations governing dissolution and transport using streamlines coupled with a parallelization approach. In addition, an analytical solution to the dissolution and transfer equations of uranium describing the In-Situ Leaching (ISL) mining recovery is found using an approximation series to the 2nd order. The analytical solution is compared to the 1D numerical resolution along the streamlines and to the 3D simulation results superimposed on the streamline. Both approaches give similar results with a relative error of \textless2 % (2%). The proposed methodology is then applied to a case study in which the classical 3D resolution is compared to the newly suggested streamline solution, demonstrating that the streamline approach increases computational performances by a factor ranging from hundred to thousand depending on the complexity of the grid-block model.
|
|
|
|
Uhrie, J. L., Drever, J. I., Colberg, P. J. S., & Nesbitt, C. C. (1996). In situ immobilization of heavy metals associated with uranium leach mines by bacterial sulfate reduction. Hydrometallurgy, 43(1), 231–239.
Abstract: Laboratory experiments with mixed populations of sulfate-reducing bactreria were shown to mediate the removal of milligrams/liter concentrations of uranium, selenium, arsenic and vanadium from aqueous solution via reduction, precipitation and adsorption. Results of laboratory experiments with active sulfidogenic biomass suggest that injection of sulfate and a source of carbon could enhance anaerobic microbial activity in and around uranium leach mines leading to in situ immobilization contaminating metals.
|
|
|
|
Tan, K., Li, C., Liu, J., Qu, H., Xia, L., Hu, Y., et al. (2014). A novel method using a complex surfactant for in-situ leaching of low permeable sandstone uranium deposits. Hydrometallurgy, 150, 99–106.
Abstract: Applications of a complex surfactant developed in-house to in-situ leaching of low permeable sandstone uranium deposits are described based on results from agitation leaching, column leaching, resin adsorption, and elution experiments using uranium containing solution from the in-situ leaching site. The results of agitation leaching experiments show that adding surfactant with different concentrations into leaching solution improves the leaching rate of uranium. The maximum leaching rate of uranium from agitation leaching reached 92.6% at an added surfactant concentration of 10mg/l. Result of column leaching experiment shows that adding surfactant with varying concentrations into leaching solutions increased the permeability coefficient of ore-bearing layer by 42.7–86.8%. The leaching rate of uranium from column leaching increased by 58.0% and reached 85.8%. The result of kinetic analysis shows that for the extraction of uranium controlled by diffusion without surfactant the apparent rate constant 0.0023/d changed to 0.0077/d for the extraction with surfactant controlled by both diffusion and surface chemical reactions. Results from resin adsorption and elution experiments show that there was no influence on resin adsorption and elution of uranium with an addition of 50mg/l surfactant to production solution from in-situ leaching. The adsorption curve, sorption capacity of resin, recycling of resin remained the same as without adding any surfactant. Introducing complex surfactant to leaching solution increased the peak concentration of uranium in eluents, reduced the residual uranium content in resin, and promoted the elution efficiency. The method of using a complex surfactant for in-situ leaching is useful for low permeable sandstone uranium deposits.
|
|
