Hdeib, R., & Aouad, M. (2023). Rainwater harvesting systems: An urban flood risk mitigation measure in arid areas. Water Science and Engineering, 16(3), 219–225.
Abstract: Rainwater harvesting (RWH) systems have been developed to compensate for shortage in the water supply worldwide. Such systems are not very common in arid areas, particularly in the Gulf Region, due to the scarcity of rainfall and their reduced efficiency in covering water demand and reducing water consumption rates. In spite of this, RWH systems have the potential to reduce urban flood risks, particularly in densely populated areas. This study aimed to assess the potential use of RWH systems as urban flood mitigation measures in arid areas. Their utility in the retention of stormwater runoff and the reduction of water depth and extent were evaluated. The study was conducted in a residential area in Bahrain that experienced waterlogging after heavy rainfall events. The water demand patterns of housing units were analyzed, and the daily water balance for RWH tanks was evaluated. The effect of the implementation of RWH systems on the flood volume was evaluated with a two-dimensional hydrodynamic model. Flood simulations were conducted in several rainfall scenarios with different probabilities of occurrence. The results showed significant reductions in the flood depth and flood extent, but these effects were highly dependent on the rainfall intensity of the event. RWH systems are effective flood mitigation measures, particularly in urban arid regions short of proper stormwater control infrastructure, and they enhance the resilience of the built environment to urban floods.
|
Robati, A., & Barani, G. A. (2009). Modeling of water surface profile in subterranean channel by differential quadrature method (DQM). Applied Mathematical Modelling, 33(3), 1295–1305.
Abstract: This study, investigates the hydraulic of flow in a subterranean channel headspring. The continuity and momentum equations of flow in porous media considering real conditions were used and the basic equation of flow in a subterranean channel was resulted. This equation is very similar to the spatially varied flow with increasing discharge. An equation, defining the hydraulic parameters of a subterranean channel section was adopted. Then differential quadrature method (DQM), was applied to the equation of flow in subterranean channel, consequently the water surface profile was resulted. To illustrate the rightness of model, the hydraulic parameters of flow in the Gavgard branch of the Joopar Goharriz Qanat were measured and the water surface profile was determined. This water surface profile was compared to the water surface profile computed by the model, which are in good agreement.
|
Rubin, R. (1988). Water conservation methods in Israel’s Negev desert in late antiquity. Journal of Historical Geography, 14(3), 229–244.
Abstract: Settlement in Israel’s Negev desert historically has been dependent on water conservation techniques. Fieldwork carried out on settlement sites constructed during the Byzantine period, when agriculture and trade flourished, revealed a variety of water installations some of which are in use today. Perennial springs in the Negev are generally small and difficult of access. Cisterns were the most common conservation devices and came in both large, enclosed and single, open forms. Cisterns were common particularly in the towns, where they were usually built as part of house foundations. Dams were discovered at several sites but proved to be inefficient and easily abandoned because of evaporation and siltation problems. Public reservoirs were part of the structure of the largest towns and were open and among the larges structures uncovered at settlement sites. Wells were distributed widely throughout the desert and were part of the only conservation system that did not depend directly on surface rainfall. A qanat system was located in the eastern Negev dating from the late settlement period before the area was abandoned at the turn of the eighth century. These various water systems raise questions about their builders and their origins, and suggests that builders originating in more humid Mediterranean environments tended to produce less adaptable installations than builders derived from the south or the east.
|
Zhang, Y., Liu, X., Yuan, S., Song, J., Chen, W., & Dias, D. (2023). A two-dimensional experimental study of active progressive failure of deeply buried Qanat tunnels in sandy ground. Soils and Foundations, 63(3), 101323.
Abstract: As an ancient underground hydraulic engineering facility, the Qanat system has been used to draw groundwater from arid regions. A qanat is a horizontal tunnel with a slight incline that draws groundwater from a higher location and delivers it to lower agricultural land. During long-term water delivery, the qanat tunnel has experienced different degrees of aging and collapse, which may result in the significant ground settlement and even disasters. This paper developed a two-dimensional laboratory system to investigate the influence of progressive failure on the stability of deeply buried qanat tunnels. The developed system is fully instrumented with a particle image velocimetry (PIV) system and earth pressure and displacement monitoring. A special cylindrical membrane tube is designed and connected to an advanced pressure–volume controller to simulate the step-wise failure process of the tunnel. Three model tests were conducted on a dry sand considering the buried qanat tunnels at three different depths. Experimental results clearly show the progressive evolution of soil arching effect in the dry sand associated with the progressive failure of the tunnels. The failure of the Qanat ground starts from the vault and develops upwards, which is closely related to the evolution of stress contour at three consecutive stages. Ground surface settlement and volume loss corresponding to three burial depths were compared. A deeply buried qanat tunnel has a small effect on surface settlement. Earth pressure evolution on the 2D plane shows the load redistribution when the qanat collapses. The maximum arch and the initial point of the limit state correspond to a volume loss of 12.5 % and 50 %, respectively. For the collapse of the deep buried qanat tunnel, ground earth pressure evolution can be divided into a stress-increasing region, stress-decreasing region, and no redistribution region. Furthermore, a multi trap-door model considering soil expansion is proposed to describe the progressive failure behavior and its effects.
|
|
Klaus, J., Külls, C., & Dahan, O. (2008). Evaluating the recharge mechanism of the Lower Kuiseb Dune area using mixing cell modeling and residence time data. Journal of Hydrology, 358(3-4), 304–316.
|
