Abstract: It is well known that rainwater harvesting (RWH) can augment water supply and reduce stormwater pollutant discharges. Due to the lack of continuous 2D modelling of urban flood coverage and its associated damage, the ability of RWH to reduce urban flood risks has not been fully evaluated. Literature suggests that small distributed storage spaces using RWH tanks will reduce flood damage only during small to medium flooding events and therefore cumulative assessment of their benefits is needed. In this study we developed a new integrated modelling framework that implements a semi-continuous simulation approach to investigate flood prevention and water supply benefits of RWH tanks. The framework includes a continuous mass balance simulation model that considers antecedent rainfall conditions and water demand/usage of tanks and predicts the available storage prior to each storm event. To do so, this model couples a rainfall-runoff tank storage model with a detailed stochastic end-use water demand model. The available storage capacity of tanks is then used as a boundary condition for the novel rapid flood simulation model. This flood model was developed by coupling the U.S. EPA Storm Water Management Model (SWMM) to the Cellular-Automata Fast Flood Evaluation (CA-ffé) model to predict the inundation depth caused by surcharges over the capacity of the drainage network. The stage-depth damage curves method was used to calculate time series of flood damage, which are then directly used for flood risk and cost-benefit analysis. The model was tested through a case study in Melbourne, using a recorded rainfall time series of 85 years (after validating the flood model against 1D-2D MIKE-FLOOD). Results showed that extensive implementation of RWH tanks in the study area is economically feasible and can reduce expected annual damage in the catchment by up to approximately 30 percent. Availability of storage space and temporal distribution of rainfall within an event were important factors affecting tank performance for flood reduction.

Abstract: Despite the attention currently given to the potential environmental benefits of large-scale forest planting, there is a shortage of clear observational evidence regarding the effects on river flows, and what there is has often been contradictory or inconclusive. This paper presents three independently conducted paired-catchment forestry studies covering 66 station-years of flow measurements in the UK and Ireland. In each case coniferous evergreen trees were removed from one catchment with minimal soil disturbance while the adjoining control catchment was left unchanged. Trees were removed from 20% – 90% of the three experimental basins. Following woodland removal there was an increase in dry weather baseflow at all sites. Baseflows increased by about 8% after tree removal from a quarter of the Hore basin and by 41% for the near-total cut at Howan. But the changes were more complex for peak flows. Tree harvesting increased the smallest and most frequent peak storm flows, indicating that afforestation would lead to the suppression of such events. This was however restricted to events well below the mean annual flood, indicating that the impact of forests upon the largest and most damaging floods is likely to be limited. Whilst a forest cover can be effective in mitigating small and frequent stormflows it should never be assumed to provide protection against major flood events.

Abstract: Combined large-scale rainwater harvesting (RWH) and flood mitigation systems are promising as a sustainable water management strategy in urban areas. These are multi-purpose infrastructure that not only provide a secondary, localised water resource, but can also reduce discharge and hence loads on any downstream wastewater networks if these are integrated into the wider water network. However, the performance of these systems is dependent on the specific design used for its local catchment which can vary significantly between different implementations. A multitude of design strategies exist, however there is no universally accepted standard framework. To tackle these issues, this paper presents a two-player optimisation framework which utilises a stochastic design optimisation model and a competing, high-intensity rainfall design model to optimise passively-operated RWH systems. A customisable tool set is provided, under which optimisation models specific to a given catchment can be built quickly. This reduces the barriers to implementing computationally complex sizing strategies and encouraging more resource-efficient systems to be built. The framework was applied to a densely populated high-rise residential estate, eliminating overflow events from historical rainfall. The optimised configuration resulted in a 32% increase in harvested water yield, but its ability to meet irrigation demands was limited by the operational levels of the treatment pump. Hence, with the inclusion of operational levels in the optimisation model, the framework can provide an efficient large-scale RWH system that is capable of simultaneously meeting water demands and reducing stresses within and beyond its local catchment.

Abstract: Drawing on advances in nonstationary frequency analysis and the science of causation and attribution, this study employs a newly developed nonstationary stochastic paired watershed approach to determine the effect of forest harvesting on snowmelt-generated floods. Moreover, this study furthers the application of stochastic physics to evaluate the environmental controls and drivers of flood response. Physically-based climate and time-varying harvesting data are used as covariates to drive the nonstationary flood frequency distribution parameters to detect, attribute, and quantify the effect of harvesting on floods in the snow-dominated Deadman River (878 km2) and nested Joe Ross Creek (99 km2) watersheds. Harvesting only 21% of the watershed caused a 38% and 84% increase in the mean but no increase in variability around the mean of the frequency distribution in the Deadman River and Joe Ross Creek, respectively. Consequently, the 7-year, 20-year, 50-year, and 100-year flood events became approximately two, four, six, and ten times more frequent in both watersheds. An increase in the mean is posited to occur from an increase in moisture availability following harvest from suppressed snow interception and increased net radiation reaching the snowpack. Variability was not increased because snowmelt synchronization was inhibited by the buffering capacity of abundant lakes, evenly distributed aspects, and widespread spatial distribution of cutblocks in the watersheds, preventing any potential for harvesting to increase the efficiency of runoff delivery to the outlet. Consistent with similar recent studies, the effect of logging on floods is controlled not only by the harvest rate but most importantly the physiographic characteristics of the watershed and the spatial distribution of the cutblocks. Imposed by the probabilistic framework to understanding and predicting the relation between extremes and their environmental controls, commonly used in the general sciences but not forest hydrology, it is the inherent nature of snowmelt-driven flood regimes which cause even modest increases in magnitude, especially in the upper tail of the distribution, to translate into surprisingly large changes in frequency. Contrary to conventional wisdom, harvesting influenced small, medium, and very large flood events, and the sensitivity to harvest increased with increasing flood event size and watershed area.

Abstract: Urban flooding in Chittagong City usually occurs during the monsoon season and a rainwater harvesting (RWH) system can be used as a remedial measure. This study examines the feasibility of rain barrel RWH system at a distributed scale within an urbanized area located in the northwestern part of Chittagong City that experiences flash flooding on a regular basis. For flood modeling, the storm water management model (SWMM) was employed with rain barrel low-impact development (LID) as a flood reduction measure. The Hydrologic Engineering Center’s River Analysis System (HEC-RAS) inundation model was coupled with SWMM to observe the detailed and spatial extent of flood reduction. Compared to SWMM simulated floods, the simulated inundation depth using remote sensing data and the HEC-RAS showed a reasonable match, i.e., the correlation coefficients were found to be 0.70 and 0.98, respectively. Finally, using LID, i.e., RWH, a reduction of 28.66% could be achieved for reducing flood extent. Moreover, the study showed that 10%–60% imperviousness of the subcatchment area can yield a monthly RWH potential of 0.04–0.45 m3 from a square meter of rooftop area. The model can be used for necessary decision making for flood reduction and to establish a distributed RWH system in the study area.