Home | << 1 2 3 4 5 6 7 >> |
Wang, B., Luo, Y., Qian, J. -zhong, Liu, J. -hui, Li, X., Zhang, Y. -hong, et al. (2023). Machine learning–based optimal design of the in-situ leaching process parameter (ISLPP) for the acid in-situ leaching of uranium. Journal of Hydrology, 626, 130234.
Abstract: The migration process of leached uranium in the in-situ leaching of uranium is considered a typical reactive transport problem. During this process, the lixiviant concentration and injection rate are important in-situ leaching process parameters (ISLPP) to efficiently recover uranium. However, several uncertain factors affect the outcomes of the ISLPP design. In addition, the repeated use of the reactive transport model (RTM) for investigating the acid in-situ leaching of uranium with the application of the Monte Carlo method leads to a substantial computational load. For this reason, a machine learning (ML)–based surrogate model was developed with the backpropagation neural network (BPNN) method to replace the RTM under the condition of uncertain parameters. Moreover, the simulated annealing optimisation model for ISLPP was created based on the proposed surrogate model. The optimal ISLPP was achieved that generated maximum profits from uranium recovery under different lixiviant prices, uranium prices and exploitation times. The optimal design framework of ISLPP based on the proposed ML algorithm was then applied in the Bayan-Uul sandstone-type uranium deposit in Inner Mongolia, China. From our analysis, it was demonstrated that the ML-based surrogate model exhibited great fitness with the RTM. The optimal results of the ISLPP indicated that the lixiviant concentration and injection rate could be adjusted based on the fluctuations in lixiviant price, uranium price and exploitation time. If the prices of sulphuric acid were high, a specific concentration of hydrogen peroxide could be injected into the injection well to promote the oxidation and dissolution of the uranium ore to increase the income from the uranium recovery. The optimisation model can also use the ISLPP scheme to boost the revenues from different lixiviant prices, uranium prices and exploitation times under the uncertainty of porosity, illustrating the applicability of the ML-based optimal design method of ISLPP in ISL mining. A general framework for developing surrogate models, as well as for conducting uncertainty analyses for a wide range of groundwater models was proposed here yielding valuable insights.
|
Burchi, S. (2018). Legal frameworks for the governance of international transboundary aquifers: Pre- and post-ISARM experience. Journal of Hydrology: Regional Studies, 20, 15–20.
Abstract: Study region Africa, Latin America, Europe. Study focus Through the extensive study and mapping of the world’s aquifers that lie astride the international boundary lines of sovereign States, ISARM has awakened concerned States to the existence of aquifers stretching beyond their borders, and precipitated cooperation in generating a body of knowledge that facilitated cooperation in governance arrangements for such aquifers. In parallel, ISARM influenced the shape and direction of the United Nations “Draft articles on the law of transboundary aquifers” appended to UN Resolution 63/124 of 2008. Both stimulated cooperation among concerned States, and provided a frame of reference for the legal grounding of such cooperation in aquifer-specific agreements. New hydrological insights Through this synergistic paradigm, ISARM has made an impact on the shape and direction of cooperation in the Guaraní Aquifer in South America, and in the Iullemeden and Taoudeni/Tanezrouft Aquifer Systems (ITAS) in the Sahel region of Africa. It is having an influence on the shape and direction of cooperation being negotiated on the Stampriet Aquifer System in Southern Africa, and on the Ocotepeque-Citalá Aquifer in Central America. The link of ISARM to other international aquifer agreements on record is tenuous, and ISARM’s influence on their generation speculative. The visibility of ISARM has faded since 2012, however its legacy is lasting.
|
Wang, B., Luo, Y., Liu, J. -hui, Li, X., Zheng, Z. -hong, Chen, Q. -qian, et al. (2022). Ion migration in in-situ leaching (ISL) of uranium: Field trial and reactive transport modelling. Journal of Hydrology, 615, 128634.
Abstract: Acid in-situ leaching (ISL) can be used as a mining technique for in situ uranium recover from underground. Acids and oxidants as lixiviants were continuously injected into a sandstone-type uranium deposit in Bayan-Uul (China). It was conducted to facilitate the dissolution of uranium minerals to generate uranyl ions, which could then be extracted for the recovery of uranium resources by the pumping cycle. A reactive transport model based on PHAST was developed to investigate the dynamic reactive migration process of uranium. The simulated results well reproduce the fluid dynamic evolution in the injecting and pumping units, as well as the dynamic release of uranium. The simulated leaching area indicates that the uranium ore leaching area was much larger than the acidification area. In addition, the pollution plume of uranium and acid water was larger than that of the leaching area, which can be used as a reference for uranium mining schemes. Furthermore, the parameter sensitivity analysis indicates the volume fraction of uranium ore and the reaction rate were the main factors affecting uranium leaching efficiency. Without considering the blockage of pores by precipitation, the Fe2+ in the reinjection fluid had a significant negative influence on uranium leaching.
|
Musy, S., Meyzonnat, G., Barbecot, F., Hunkeler, D., Sültenfuss, J., Solomon, D. K., et al. (2021). In-situ sampling for krypton-85 groundwater dating. Journal of Hydrology X, 11, 100075.
Abstract: Krypton-85 and other radioactive noble gases are widely used for groundwater dating purposes. 85Kr analysis require large volumes of water to reach the analytical requirements. Conventionally, this water is pumped to the surface to be degassed with a gas extraction system. The large pumping rate may disturb the natural flow field and requires substantial field logistics. Hence, we propose a new in-situ degassing method, in which membrane contactors are used to degas the groundwater directly in the well and gas is collected at the surface. This way, field work is facilitated, groundwater system disturbance is minimized, and the gas sample is collected at a specific depth. We demonstrate the tightness of the system regarding atmospheric air contamination for a collection times of 24 h, which is sufficient for both low-level counting and laser-based counting methods for 85Kr. The minimal borehole diameter is 7.5 cm for the prototype presented in this research but can easily be reduced to smaller diameters. In a case study, we compare the results obtained with the new passive method with those from a conventional packer setup sampling. Additionally, 3H/3He samples were collected for both sampling regimes and the dating results were compared with those from 85Kr. A good agreement between tracer ages is demonstrated and the age stratigraphy is consistent with the expected age distribution for a porous unconfined aquifer. In addition, our study emphasizes the differences between the age information sampled with various methods. In conclusion, we demonstrate that the new in situ quasi-passive method provides a more representative age stratigraphy with depth in most cases.
|
Ibrahim, A. S., Zayed, I. S. A., Abdelhaleem, F. S., Afify, M. M., Ahmed, A., & Abd-Elaty, I. (2023). Identifying cost-effective locations of storage dams for rainfall harvesting and flash flood mitigation in arid and semi-arid regions. Journal of Hydrology: Regional Studies, 50, 101526.
Abstract: Study region Wadi Tayyibah is located in south Sinai, Egypt, in a region called Abou Zenima, and it is used to develop this study. Study focus Flash floods tremendously impact many facets of human life due to their destructive consequences and the costs associated with mitigating efforts. This study aims to evaluate the harvesting of Runoff by delineating the watersheds using the Hydrologic Engineering Center-1 (HEC-1) model and ArcGIS software in trying to benefit from it in different ways. All morphometric parameters of the basin were considered, and the risk degree of the different sub-basins was determined. The suitable locations of dams were identified using a Geographical Information System (GIS) using the basin’s morphometric characteristics. New hydrological insights for the region The study proposed a total number of eight dams, including five dams that were recommended for sub-basin (1) and three dams in sub-basin (4), while sub-basins (2) and (3) are not suitable locations to build dams according to the contour map of Wadi Tayyibah. Results indicate that, based on the constructed flash flood hazard maps and the basin’s detailed morphometric characteristics, the best locations of dams are Dam (3) in sub-basin (1) and Dam (7) in sub-basin (4), where the runoff volume reached 3.13 million cubic meters (Mm3) and 5.56 Mm3 for return period 100, respectively. This study is useful for decision-makers and designers for using morphometric parameters and flash flood hazard degree maps to select dam locations. Also, the cost-benefit analysis for using the morphometric parameters is required to be investigated.
|