Abstract: Population increase, climate change and soil impermeability are factors causing floods in large urban centres. Such places also always have water shortage problems. This research aims to evaluate the influence of rainwater harvesting in residential buildings on stormwater in a basin located in southern Brazil (Rio Cachoeira Basin). Urbanised and non-urbanised areas, soil types, curve numbers and time of concentration of each sub-basin were taken into account. Through the HEC-HMS programme, it was possible to calculate hydrographs for the base scenario (when there is no rainwater harvesting). Then, rainwater tanks for the residential buildings were sized using the computer programme Netuno. In the second scenario, there is rainwater harvesting in all residential buildings. Thus, the hydrographs for the second scenario were also calculated. The peak flow reduction potentials for the sub-basins ranged from 2.7% to 14.3%. The highest percentage (14.3%) did not occur in the sub-basin with the most extensive roof area; such highest peak flow reduction occurred in Bom Retiro sub-basin. In Bom Retiro sub-basin, there are more houses than multi-storey residential buildings. Even when considering the full potential of rainwater harvesting for roof areas of all existing buildings in the Rio Cachoeira Basin, the average potential reduction in peak flow was 7.2%. The conclusion is that rainwater tanks in residential buildings have little influence on stormwater runoff, and the stormwater runoff will be less affected when the area of the hydrographic basin is larger. Thus, the reduction in peak flows is insignificant when considering the flooding in the region.

Abstract: Cities have experienced rapid urbanization-induced harsh climatic events, especially flooding, inevitably resulting in negative and irreversible consequences for urban resilience and endangering residents’ lives. Numerous studies have analyzed the effects of anthropogenic practices (land use changes and urbanization) on flood forecasting. However, non-structural mitigation’s effectiveness, like Nature-Based Solutions (NBS), has yet to receive adequate attention, particularly in the Middle East and North Africa (MENA) region, which have become increasingly significant and indispensable for operationalizing cities efficiently. Therefore, our study investigated the predictive influence of incorporating one of the most common NBS strategies called low-impact development tools (LID) (such as rain gardens, bio-retention cells, green roofs, infiltration trenches, permeable pavement, and vegetative swale) during the urban planning of Alexandria, Egypt, which experiences the harshest rainfall annually and includes various urban patterns. City characteristics-dependent 14 LID scenarios were simulated with recurrence intervals ranging from 2 to 100 years using the LID Treatment Train Tool (LID TTT), depending on calibrated data from 2015 to 2020, by the Nash-Sutcliffe efficiency index and deterministic coefficient, and root-mean-square error with values of 0.97, 0.91, and 0.31, respectively. Our findings confirmed the significant effectiveness of combined LID tools on total flood runoff volume reduction by 73.7%, revealing that different urban patterns can be used in flood-prone cities, provided LID tools are considered in city planning besides grey infrastructure to achieve optimal mitigation. These results, which combined multiple disciplines and were not explicitly mentioned in similar studies in developing countries, may assist municipalities’ policymakers in planning flood-resistant, sustainable cities.

Abstract: Droughts and floods are weather-related hazards affecting cities in all climate zones and causing human deaths and material losses on all inhabited continents. The aim of this article is to review, analyse and discuss in detail the problems faced by urban ecosystems due to water surplus and scarcity, as well as the need of adaptation to climate change taking into account the legislation, current challenges and knowledge gaps. The literature review indicated that urban floods are much more recognised than urban droughts. Amongst floods, flash floods are currently the most challenging, which by their nature are difficult to monitor. Research and adaptation measures related to water-released hazards use cutting-edge technologies for risk assessment, decision support systems, or early warning systems, among others, but in all areas knowledge gaps for urban droughts are evident. Increasing urban retention and introducing Low Impact Development and Nature-based Solutions is a remedy for both droughts and floods in cities. There is the need to integrate flood and drought disaster risk reduction strategies and creating a holistic approach.

Abstract: Uranium is used as a fuel for nuclear power plant and can be extracted from different ores, mainly acidic (silicious ore) and alkaline (carbonate ore). Recovery of uranium through acid leaching from silicious ore is well established, whereas, alkaline leaching from carbonate ore is challenging due to the excessive salinity of leach liquor and high concentration of carbonate, bicarbonate and sulphate. Herein, two monomers, acrylic acid (AA) and N, N-methylene bisacrylamide (BAM), selective towards uranyl were intercalated in-situ into the interlayer, followed by their polymerization and cross-linking to form novel polymer intercalated hybrid layered double hydroxide (LDH). The LDH acts as a backbone to overcome coiling and swelling of polymer and anchors them as free-standing. Various parameters, like, the type of metal ions, monomer ratio (AA: BAM) and metal ion ratio (M2+:M3+), were studied to determine the optimum conditions for effective intercalation and polymerization of monomers. Magnesium aluminum (MgAl) LDH with a cross-linked polymer having a monomer ratio of 3:2 (AA: BAM) as intercalating species showed maximum efficiency of uranyl adsorption (1456 mg/g at 30 °C) with highest capacity so far. The distribution coefficient (Kd, l/mg) in the order of 105 suggested that the adsorbent was highly selective for uranyl in the presence of different cations, anions and humic acid. The adsorbent extracts uranium effectively and selectively from a real-life alkaline leach liquor with an efficiency of 96% at 5 g/l dose. Uranium can be recovered from the adsorbent in the form of sodium di-uranate using 2(M) NaOH and was reused for eight cycles.

Abstract: Most of the World’s germanium (Ge) is mined from Ge-rich lignite, where it is commonly associated with elevated arsenic (As), tungsten (W) and beryllium (Be) contents. Over the past decade, new evidence showing that World-class Ge deposits result from the interaction of hydrothermal fluids with organic matter in coal seams has emerged. Yet, the chemical state of Ge and associated metals in lignite remains poorly understood. We used Mega-pixel Synchrotron X-ray Fluorescence (MSXRF), X-ray Absorption Near Edge Structure (XANES) and Extended X-ray Absorption Fine Structure (EXAFS) to characterize the oxidation states and chemical bonding environment of Ge, As, and W in two world-class Mesozoic Ge-in-lignite deposits (Lincang, Yunnan, southwestern China; Wulantuga, Inner Mongolia, northeastern China); in lignite-bearing uranium (U) ores from the Beverley deposit (South Australia) hosted in Eocene sandstones; and in lignite and preserved wood in late Oligocene-Miocene fluviatile sediments (Gore, Southland, New Zealand). The aim was to improve our understanding of the enrichment mechanism of Ge in lignite and better evaluate the environmental mobility of Ge and some of the associated metals (specifically As and W) in lignite ores. In all samples, chemical maps show that Ge is distributed homogeneously (down to 2μm) within the organic matter. XANES and EXAFS data show that Ge exists in the tetravalent oxidation state and in a distorted octahedral coordination with O, consistent with complexing of Ge by organic ligands. In some pyrite-bearing samples, a minor fraction of Ge is also present as Ge(IV) in association with pyrite. In contrast, As displays a more complex speciation pattern, sometimes even in a single sample, including As(III), As(V), and As(−I/+II) in solid solution in sulfides. Arsenic in sulfides occurs in anionic and cationic forms, i.e., it shows both the common substitution for S22− and the substitution for Fe recently discovered in some hydrothermal pyrites. Tungsten was present as W(VI) in distorted octahedral (3+3) coordination. The EXAFS data confirm the absence or minor contribution of individual W-rich minerals such as scheelite or ferberite to W mass balance in the studied samples. These data show that Ge, W, and probably some As are scavenged via formation of insoluble, oxygen-bridged metal organic complexes in lignite. Destruction of the organic ligands responsible for fixing Ge and W (As) in these lignites is required for liberating the metals, e.g. from waste materials. Geochemical modelling suggests that Ge, W, Be and As all can be extracted from granitic rocks by dilute, low temperature hydrothermal fluids. Germanium is transported mainly as the tetrahedral Ge(OH)4(aq) complex, but fixed as an octahedral oxy-bridged organic complex. The same situation is valid for W, which is transported at the tetrahedral tungstate ion, but most likely scavenged via formation of a 6-coordinated metal-organic species. The Ge-Be-W±As association in Ge-rich coals reflects the source of the metals as well as related scavenging mechanisms.