Abstract: Krypton-85 and other radioactive noble gases are widely used for groundwater dating purposes. 85Kr analysis require large volumes of water to reach the analytical requirements. Conventionally, this water is pumped to the surface to be degassed with a gas extraction system. The large pumping rate may disturb the natural flow field and requires substantial field logistics. Hence, we propose a new in-situ degassing method, in which membrane contactors are used to degas the groundwater directly in the well and gas is collected at the surface. This way, field work is facilitated, groundwater system disturbance is minimized, and the gas sample is collected at a specific depth. We demonstrate the tightness of the system regarding atmospheric air contamination for a collection times of 24 h, which is sufficient for both low-level counting and laser-based counting methods for 85Kr. The minimal borehole diameter is 7.5 cm for the prototype presented in this research but can easily be reduced to smaller diameters. In a case study, we compare the results obtained with the new passive method with those from a conventional packer setup sampling. Additionally, 3H/3He samples were collected for both sampling regimes and the dating results were compared with those from 85Kr. A good agreement between tracer ages is demonstrated and the age stratigraphy is consistent with the expected age distribution for a porous unconfined aquifer. In addition, our study emphasizes the differences between the age information sampled with various methods. In conclusion, we demonstrate that the new in situ quasi-passive method provides a more representative age stratigraphy with depth in most cases.

Abstract: The calculation of a groundwater recharge temperature based on the dissolved concentrations of Ne, Ar, Kr and Xe requires a correction for noble gas supersaturation due to excess air entrainment. This entrainment is commonly attributed to the recharge process or to air contamination at the wellhead during sample collection. With the exception of some local studies, most work has concentrated on interpretation of the recharge temperature or quantification of the radiogenic content for palaeoclimatic and dating purposes. The magnitude and source of the excess air is not directly relevant to these studies and so is often ignored. In this work, excess air Ne and other data have been calculated from new and published noble gas data sets for several groundwater systems. For younger groundwaters which have been recharged under one broad climatic regime, the amount of air entrainment increases according to lithology in the order granites, sandstones and limestones respectively. A negative correlation between precipitation and excess air entrainment is identified in at least one aquifer, and some of the mechanisms which may influence the entrainment process are discussed.

Abstract: Urban flooding in Chittagong City usually occurs during the monsoon season and a rainwater harvesting (RWH) system can be used as a remedial measure. This study examines the feasibility of rain barrel RWH system at a distributed scale within an urbanized area located in the northwestern part of Chittagong City that experiences flash flooding on a regular basis. For flood modeling, the storm water management model (SWMM) was employed with rain barrel low-impact development (LID) as a flood reduction measure. The Hydrologic Engineering Center’s River Analysis System (HEC-RAS) inundation model was coupled with SWMM to observe the detailed and spatial extent of flood reduction. Compared to SWMM simulated floods, the simulated inundation depth using remote sensing data and the HEC-RAS showed a reasonable match, i.e., the correlation coefficients were found to be 0.70 and 0.98, respectively. Finally, using LID, i.e., RWH, a reduction of 28.66% could be achieved for reducing flood extent. Moreover, the study showed that 10%–60% imperviousness of the subcatchment area can yield a monthly RWH potential of 0.04–0.45 m3 from a square meter of rooftop area. The model can be used for necessary decision making for flood reduction and to establish a distributed RWH system in the study area.

Abstract: Permeable reactive barriers (PRBs) are used for groundwater remediation at contaminated sites worldwide. This technology has been efficient at appropriate sites for treating organic and inorganic contaminants using zero-valent iron (ZVI) as a reductant and as a reactive material. Continued development of the technology over the years suggests that a robust understanding of PRB performance and the mechanisms involved is still lacking. Conflicting information in the scientific literature downplays the critical role of ZVI corrosion in the remediation of various organic and inorganic pollutants. Additionally, there is a lack of information on how different mechanisms act in tandem to affect ZVI-groundwater systems through time. In this review paper, we describe the underlying mechanisms of PRB performance and remove isolated misconceptions. We discuss the primary mechanisms of ZVI transformation and aging in PRBs and the role of iron corrosion products. We review numerous sites to reinforce our understanding of the interactions between groundwater contaminants and ZVI and the authigenic minerals that form within PRBs. Our findings show that ZVI corrosion products and mineral precipitates play critical roles in the long-term performance of PRBs by influencing the reactivity of ZVI. Pore occlusion by mineral precipitates occurs at the influent side of PRBs and is enhanced by dissolved oxygen and groundwater rich in dissolved solids and high alkalinity, which negatively impacts hydraulic conductivity, allowing contaminants to potentially bypass the treatment zone. Further development of site characterization tools and models is needed to support effective PRB designs for groundwater remediation.

Abstract: 4He concentrations in excess of the solubility equilibrium with the atmosphere by up to two to three orders of magnitude are observed in the Carrizo Aquifer in Texas, the Ojo Alamo and Nacimiento aquifers in the San Juan Basin, New Mexico, and the Auob Sandstone Aquifer in Namibia. A simple 4He accumulation model is applied to explain these excess 4He concentrations in terms of both in situ production and a crustal flux across the bottom layer of the aquifer. Results from the model simulations suggest variability in the 4He fluxes, ranging from 6×10−6 cm3 STP cm−2 yr−1 for the Auob Sandstone Aquifer to 3.6×10−7 cm3 STP cm−2 yr−1 for the Carrizo aquifer. For the Ojo Alamo and Nacimiento aquifers an intermediate value of 3×10−6 cm3 STP cm−2 yr−1 was estimated. The contribution of in-situ produced 4He to the measured concentrations was also estimated. This contribution is negligible for the Auob Sandstone Aquifer as compared with both the concentrations measured at the top and bottom of the aquifer for most of the pathway. In the Carrizo aquifer, in-situ produced 4He contributes 27.5% and 15.4%, to the total 4He observed at the top and bottom of the aquifer, respectively. For both aquifers of the San Juan Basin in-situ production almost entirely dominates the 4He concentrations at the top of the aquifer for most of the pathway. In contrast, the internal production is negligible as compared with the measured concentrations at the bottom of these aquifers, reaching, at most, 1.1%. The model simulations require an exponential decrease in the horizontal velocity of the water with increasing recharge distance to reproduce the distribution of 4He in these aquifers. For the Auob Sandstone Aquifer the highest range in the velocity values is obtained (25 to 0.4 m yr−1). The simulations for the Carrizo aquifer and both aquifers located in the San Juan Basin require velocities varying from 4 to 0.1 m yr−1, and from 2 to 0.3 m yr−1, respectively. For each aquifer, average permeability values were also estimated. They are generally in agreement with results obtained from pumping tests, hydrodynamic modeling and previous 14C measurements. On the basis of the results obtained by calibrating the model with the measured 4He concentrations, the mean water residence times were estimated. They agree reasonably well with 14C ages. When applied as chronologies for noble gas temperatures in the same aquifers, the calculated 4He ages allow the identification of three different climate periods similar to those previously identified using 14C ages: (1) the Holocene period (0–10 Ka BP), (2) the Last Glacial Maximum (≈18 Ka BP), and (3) the preceeding period (30–150 Ka BP).