Abstract: Combined large-scale rainwater harvesting (RWH) and flood mitigation systems are promising as a sustainable water management strategy in urban areas. These are multi-purpose infrastructure that not only provide a secondary, localised water resource, but can also reduce discharge and hence loads on any downstream wastewater networks if these are integrated into the wider water network. However, the performance of these systems is dependent on the specific design used for its local catchment which can vary significantly between different implementations. A multitude of design strategies exist, however there is no universally accepted standard framework. To tackle these issues, this paper presents a two-player optimisation framework which utilises a stochastic design optimisation model and a competing, high-intensity rainfall design model to optimise passively-operated RWH systems. A customisable tool set is provided, under which optimisation models specific to a given catchment can be built quickly. This reduces the barriers to implementing computationally complex sizing strategies and encouraging more resource-efficient systems to be built. The framework was applied to a densely populated high-rise residential estate, eliminating overflow events from historical rainfall. The optimised configuration resulted in a 32% increase in harvested water yield, but its ability to meet irrigation demands was limited by the operational levels of the treatment pump. Hence, with the inclusion of operational levels in the optimisation model, the framework can provide an efficient large-scale RWH system that is capable of simultaneously meeting water demands and reducing stresses within and beyond its local catchment.

Abstract: Despite the attention currently given to the potential environmental benefits of large-scale forest planting, there is a shortage of clear observational evidence regarding the effects on river flows, and what there is has often been contradictory or inconclusive. This paper presents three independently conducted paired-catchment forestry studies covering 66 station-years of flow measurements in the UK and Ireland. In each case coniferous evergreen trees were removed from one catchment with minimal soil disturbance while the adjoining control catchment was left unchanged. Trees were removed from 20% – 90% of the three experimental basins. Following woodland removal there was an increase in dry weather baseflow at all sites. Baseflows increased by about 8% after tree removal from a quarter of the Hore basin and by 41% for the near-total cut at Howan. But the changes were more complex for peak flows. Tree harvesting increased the smallest and most frequent peak storm flows, indicating that afforestation would lead to the suppression of such events. This was however restricted to events well below the mean annual flood, indicating that the impact of forests upon the largest and most damaging floods is likely to be limited. Whilst a forest cover can be effective in mitigating small and frequent stormflows it should never be assumed to provide protection against major flood events.

Abstract: It is well known that rainwater harvesting (RWH) can augment water supply and reduce stormwater pollutant discharges. Due to the lack of continuous 2D modelling of urban flood coverage and its associated damage, the ability of RWH to reduce urban flood risks has not been fully evaluated. Literature suggests that small distributed storage spaces using RWH tanks will reduce flood damage only during small to medium flooding events and therefore cumulative assessment of their benefits is needed. In this study we developed a new integrated modelling framework that implements a semi-continuous simulation approach to investigate flood prevention and water supply benefits of RWH tanks. The framework includes a continuous mass balance simulation model that considers antecedent rainfall conditions and water demand/usage of tanks and predicts the available storage prior to each storm event. To do so, this model couples a rainfall-runoff tank storage model with a detailed stochastic end-use water demand model. The available storage capacity of tanks is then used as a boundary condition for the novel rapid flood simulation model. This flood model was developed by coupling the U.S. EPA Storm Water Management Model (SWMM) to the Cellular-Automata Fast Flood Evaluation (CA-ffé) model to predict the inundation depth caused by surcharges over the capacity of the drainage network. The stage-depth damage curves method was used to calculate time series of flood damage, which are then directly used for flood risk and cost-benefit analysis. The model was tested through a case study in Melbourne, using a recorded rainfall time series of 85 years (after validating the flood model against 1D-2D MIKE-FLOOD). Results showed that extensive implementation of RWH tanks in the study area is economically feasible and can reduce expected annual damage in the catchment by up to approximately 30 percent. Availability of storage space and temporal distribution of rainfall within an event were important factors affecting tank performance for flood reduction.

Abstract: Intense urbanisation in many coastal areas has led to intensification of groundwater consumption, while reducing permeable areas and increasing the frequency and magnitude of flooding. Among the potential strategies to compensate for these adverse effects, which are expected to become worse as a result of climate change, rooftop rainwater harvesting (RWH) in combination with managed aquifer recharge (MAR), may be indicated. This work investigated the performance of different configurations of such a system, tested as a twofold sustainable stormwater and domestic water management tool in a tropical metropole (João Pessoa, Brazil). This area located over a sedimentary aquifer system illustrates the water security challenges of densely urbanised areas in southern cities. To that end, several configurations of rooftop catchments and storage volumes were evaluated, by simulating a MAR-RWH system connected to the regional unconfined aquifer (Barreiras Formation) through a 6″ diameter injection well. Rainfall-runoff-recharge processes and water balances were simulated using monitored high-temporal resolution rainfall data. The results showed that catchments ranging from 180 to 810 m2, connected to tanks from 0.5 to 30.0 m³, are the optimal solutions in terms of efficient rainwater retention and peak flow reduction. These solutions provided mean annual estimates of aquifer recharge between 57 and 255 m³/yr from 2004 to 2019. The results of this study highlight the opportunity for MAR schemes to reconcile stormwater management and water supply goals.

Abstract: The development of agriculture sector and livelihood in Bangladesh are threatened by various climatic stressors, including flash flooding. Therefore, Extension and advisory services (EAS) need to navigate the knowledge landscape effectively to connect various farm actors and help secure the optimum benefits of knowledge and information for making rational decisions. However, little is known how EAS can perform this task to combat various effects of climate change. This study investigates the means of brokering knowledge by the EAS to help the farming sector adapt to flash flooding. The research was conducted in the north-eastern part of Bangladesh with 73 staff of the Department of Agricultural Extension (DAE), the largest public EAS in Bangladesh. The results showed that DAE primarily dealt with crop production-related information. However, EAS did not navigate knowledge and information about flash flooding, such as weather forecasting and crop-saving-embankments updates, among the farming actors. Moreover, they missed the broad utilization of internet-based-communication channels to rapidly navigate information and knowledge about possible flash flooding and its adaptation strategies. This article provides some policy implications to effectively support the adaptation of farming system to flash flooding through EAS.